This product uses an infrared remote control to adjust brightness and dynamic change modes. It features delay shutdown settings and memory function, eliminating the need for frequent reconfiguration. Compatible with all single-color LED strip lights. Product Name: IR Remote Controller Dimmer LED Type: High Power LED Input/Output Voltage: DC 12-24V Working Temperature: -20°C to +60°C Power Rating: 360W Output Current: 30-36A Remote Battery: 2 x AAA (battery not included) Control Distance: Up to 10 meters Instructions: 1. Connect the LED strip plug to the controller output socket, ensuring correct polarity alignment. Check for any short circuits before powering on. If a short circuit is detected, resolve it immediately to prevent damage to the controller or LED strip. 2. Plug in the power supply and turn on the power. Use the remote control to operate the device according to your requirements. 3. When installing the infrared remote control model, position the receiver where it is not obstructed by barriers to ensure proper signal reception and avoid malfunctions. 4. Radio frequency models can operate through obstacles. Function Mode List: 1. ON/OFF – Turn power on or off 2. SPEED / SPEED+ – Adjust dynamic effect speed 3. LIGHT – Set to maximum brightness 4. UP/DOWN – Adjust brightness level 5. MODE+ / MODE- – Select from 8 dynamic lighting modes: Gradient, Breath, Flash, Slow Flash, Quick Flash, Skip, Blink, Candle Light 6. 10%-100% – Choose brightness percentage 7. TIME 5-60 – Set delay shutdown time (5 to 60 minutes) Color: White + Silver Material: Plastic + Metal Package Contents: 1 x Controller 1 x Remote Control Note: The package includes only the items listed above. Other accessories are not included. Lighting and display differences may cause slight color variations between the product image and actual item. Measurement tolerance: ±1-3 cm.