OBD2 Scanner USB Interface compatible with compatible withd and Mazda, Works with compatible withScan Software

OBD2 Scanner USB Interface for Ford and Mazda, Works with FORScan Software A. Latest ELM327 version for greater Ford compatibility B. Manufactured modification to include a switch to connect to different CAN buses C. Designed for FORScan software D. Compatible with software vendors: FORScan, Elmconfig (supports Baud rate: 34800, please check before ordering), FF2 and FoCCCus, plus more E. Basic Features: Reset fault / trouble codes / parameter ids (PIDs), Change car configuration data, Run tests, Services procedures F. MS CAN bus and HS CAN bus support G. ELM327 USB 25k80 With Switch For Ford Diagnostic Cable H. Product Introduction: One ELM327 OBDII OBD2 USB with switch. Designed for communicating with Ford, Mazda vehicles. With this cable and one of the supported software vendors, you can detect modules which are not visible for regular OBD2 scanners. This includes showing trouble codes, PIDs, running tests and services procedures which are not displayed by other OBD2 scanners and a standard ELM327. I. Pin Configurations: Switch outside: HS CAN - Occupies pins 6 and 14; Switch inside: MS CAN - Occupies pins 3 and 11 J. Supported Software: FORScan; Elmconfig (supports Baud rate: 34800, please check before ordering); FoCCCus K. Modified ELM: Please note that many Ford and Mazda models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the regular HS CAN bus. In contrast to HS CAN bus, MS CAN bus is not supported by the stock ELM327, because MS CAN is a manufacturer-specific solution and located on non-OBD2 pins. This ELM327 has been modified to allow it to implement the MS CAN bus. ELM327 supports HS CAN from the stock, because Ford HS CAN matches OBD2 standards. It occupies pins 6 and 14. MS CAN bus occupies pins 3 and 11. L. Color: As Shown M. Material: ABS N. Package Contents: 1 x Diagnostic Scan Tool; Only the above package content, other products are not included