Description 1. Latest ELM327 version for greater Ford compatibility 2. Manufactured modification to include a switch to connect to different CAN buses 3. Designed for FORScan software 4. Compatible with software providers: FORScan, Elmconfig (Only supports Baud rate:34800, check before ordering), FF2 and FoCCCus, plus more Basic functions: Reset errors / trouble codes / parameter ID (PID), Change vehicle configuration data, Run tests, Service procedures MS CAN bus and HS CAN bus support ELM327 USB 25k80 With Switch For Ford DiagnosticCable Product introduction: An ELM327 OBDII OBD2 USB with switch. Designed to communicate with Ford, Mazda vehicles. With this cable and one of the supported software providers, you can discover modules that are not visible to standard OBD2 scanners. This includes showing you trouble codes, PIDs, running tests and service procedures that are never shown by other OBD2 scanners and a standard ELM327. Pin configurations: Switch outside: HS CAN - Pins 6 and 14 occupied Switch inside: MS CAN - Pins 3 and 11 occupied Supported software: FORScan Elmconfig (Only supports Baud rate: 34800, check before ordering) FoCCCus Modified EML: Please note that many Ford and Mazda models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the standard HS CAN bus. Unlike the HS CAN bus, the MS CAN bus is not supported by the standard ELM327, as MS CAN is a manufacturer-specific solution and is located on non-OBD2 pins. This ELM327 has been modified to allow it to implement the MS CAN bus. The ELM327 supports HS CAN by default, as the Ford HS CAN fully matches the OBD2 standards. It occupies pins 6 and 14. The MS CAN bus occupies pins 3 and 11. Color: As shown Material: ABS Package Contents: 1 * Diagnostic Scan Tool Only the above package contents, other products are not included.b