Adjustable Timer Relay Switch, 1-480Min Delay Controller, AC 110V/220V Power-On Delay OFF, 7A Voltage Output

Function: Delay for a period of time to stop power supply. Small size, simple to use, stable performance. Module function: This module is a delayed shutdown module. When the set delay time expires, the power supply is stopped. Wide range of uses: such as exhaust fans, motors, air coolers, cooling fans, germicidal lamps, humidifiers, heaters, etc. Applicable scenes: living room, kitchen, bathroom, bedroom, corridor, stairs, etc. Parameters: Output current: 7A (MAX 10A) Working power consumption: 43mA Output voltage: AC110-220V Power supply voltage: AC110-220V Maximum standby power consumption: 12mA Number of control channels: 1 output Working temperature: -25°C to 85°C Working humidity: 5% to 95% RH Control power: 1400W max for incandescent lamp, 300W max for energy saving lamp Equipped with LED indicator to show working status (constant light means working, flashing means delay is over) 16 delay modes available: 1, 3, 5, 10, 15, 25, 30, 40, 50, 60, 90, 120, 180, 240, 300, and 480 minutes Working status: After power on, the indicator light (PWR) stays on; after delay completes, the indicator light flashes. Instructions: - Set the required delay time (do not set while powered); - After confirming correct wiring, power on. Upon power on, the module starts working (indicator light stays on). When the delay time ends, the module stops power supply (indicator light flashes). 1. To shut down early during operation, disconnect the main power supply of the module. 2. To start a new delay cycle, power on again. Color: As shown Material: PCB + Components Style: B with housing Note: Appearance may vary slightly due to different product batches; this does not affect functionality. Package Contents: 1 x Delay Relay Switch Only the above items are included; other items are not part of the package. Note: Lighting and display differences may cause slight color variations between the image and actual item. Measurement error allowed is +/- 1-3 cm.