Features: 1. If you are tired of water spreading in the bathroom and kitchen, install this water retaining strip to help prevent water from flowing out. 2. The long, flexible design allows it to conform to various shapes and surfaces. 3. Acts as a shower barrier and retention system to help keep water contained within the threshold area. 4. Ideal for use in curbless showers and other wet areas where water control is needed. 5. Features a self-adhesive backing for easy installation; sits close to the ground to help reduce water leakage. Important Notice before applying the Water Barrier Strip: 1. The back of the strip has adhesive for temporary assistance only. For proper installation and sealing, silicone sealant (glass glue) must be applied to both sides and ends of the strip. 2. Clean the surface thoroughly and ensure it is free of dust, moisture, and debris before application. 3. Determine the desired placement and mark the outline with a pen. 4. Peel off the backing film and position the strip along the marked area. 5. Apply silicone sealant along the edges where the strip meets the wall and floor to ensure a secure, watertight seal. 6. For best results, apply silicone sealant to both sides of the strip and allow it to cure for approximately 24 hours before use. Note: - Actual color may vary slightly due to differences in monitor displays and lighting conditions. - Allow for a 1–3 cm measurement tolerance due to manual measurement. Specifications: Type: Water Barrier Strip Material: Silicone with self-adhesive backing Size: Width 1.6 cm, Height 3.0 cm Length options: 0.5 / 1.2 / 1.5 / 1.8 / 2 / 2.5 / 3 meters Package includes: 1 x Water Barrier Strip