Condition: Brand New <br>Item Type: Nitrogen Regulator <br>Material: Brass <br>Use Medium: Nitrogen <br>Maximum Inlet Pressure: 15MPa <br>Maximum Outlet Pressure: 4MPa <br>Flow Rate: 16Nm3/h <br>Adjustment Screw Rod: After installation, turn the adjustment screw clockwise to adjust the input pressure 0.4MPA-4MPA <br>Input Filter: Filter protects the pressure reducer <br>Input Interface: Outer diameter 8mm/0.3in, 10mm/0.4in output end, double sealing and leakproof setting <br>Dial Diamter: Approx. 60mm / 2.4in <br>Weight: Approx. 1728g / 61oz<br>1、High?quality brass material to prevent air leakage, good sealing and anti?corrosion, durable in use. <br>2、Adjustment screw rod, turn the adjusting screw clockwise after installation, you can adjust the input pressure 0.4MPA?4MPA. <br>3、The two pressure gauge dials are covered with anti?skid plastic protective film, the scale is clearly visible and does not fade. <br>4、Low?pressure gauge, dial diameter is 60MM, rated input pressure is 0.4MPA?4MPA, pressure reaches 4x1.3=5.2MPA. <br>5、High?pressure gauge, dial diameter is 60MM, rated input pressure is 1MPA?15MPA, the input pressure is prohibited to exceed the rated input pressure.1. When installing the pressure reducing valve, you should check that the specifications of the gas cylinder connection are the same, and open the gas cylinder instantly, and then connect the pressure reducer after blowing out the garbage, so as to prevent impurities from entering the pressure reducer. <br>2. When opening the safety valve, avoid standing on the front of the pressure reducer and the outlet, and open slowly to avoid accidents.<div>1 x Nitrogen Regulator</div><div>1 x Adjustment Screw Rod</div>