20W/mSelf-regulating Heating Tape Snow MeltingDrain Water Pipe Freeze Protection Heat Cable<br> Cable type: self-regulating heating cable<br> 1. Working voltage: 200~240V AC<br> 2. Rated power: 20W/m (at 10C degrees)<br> 3. Max maintain temperature: 65C degrees<br> 4. Max enduring temperature: 135C degrees<br> 5. Width * Thickness: 8.1mm * 3mm<br> 6. Min bend radius: 15mm<br> 7. Conductor: tinned copper wire<br> 8. Jacket:PE<br> 9. Max circuit length: 30m<br> 1. Copper conductor<br> 2. Conductive heating element<br> 3. I<br> nside<br> extra insulation<br> 4. PE outer sheath<br> Installation Steps:<br> 1) Seal the end of the cable with heat shrinkable tube or other electrical insulatingtape.<br> DO NOT connect the two conductors together<br> 2) Connect the other end with cold wire or plug (for connecting to the power supply).<br> 3) Wrapthe heating cable on water pipes or fastening straight on pipes, both are ok. Put the whole cable on the pipes and fasten it every 30~60cm with thermal tape or aluminum tape(sold in my store).<br> 4) Suggest to wrap a layer of rubber insulation on the pipe, enhance efficiency of the heating cable and save energy, also can protect the heating cables.<br> 5) Connect or plug into 220~240V. The heat trace system is finished.<br> Tips: max circuit length ~ 30 meters.<br> Installation onPipes:<br> <br> Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement. Sold by-DIMEANI official store