[Great Compatibility] 005-302-4300-03 Water Valve Top Dome Complete Assembly Comes with new Valve Dome, Pressure Gauge (005-302-3590-00), Pause Assembly (005-302-3502-00). Replaces for Valve Top for PCC 2000, for Paddock PCC 2000, for Cyclean, for Pool Valet, for PV3, for Vanquish, for Andrews Advantage PCC2000 and for Vantage In-Floor Cleaning Systems. All Part Numbers used for this part: 005302430003 / 005-302-4300-03 / 005302430060 / 005-302-4300-60. [Perfect Design] 2 to 12 port flexibility, convenient pause mode, and water-powered, non-electric design. Work with 2 / 3 / 6 / 9 / 12 port system. The run/pause switch at the top of the valve allows you to conveniently pause the system to isolate the circuits inside and outside the pool. The PSI gauge is designed with a clearly marked sliding pressure gauge to indicate the operation of the system and when the pressure has increased to the point where the filter needs to be cleaned. [Features & Advantages] No electricity needed and lowers heating costs. Reduces chemical costs and electrical consumption up to 30%. No need for vacuum devices and unsightly hoses. It's recommended to use pipe dope or joint stick, instead of tape. Hand tighten the gauge to prevent overtightening and breakage. [Easy to Install & Use] One-piece replacement design allows for easy installation. Simply turn the pump off. Take the knob off. the band clamp and the dome off the water valve. Undo the cap and hand tighten the gauge on. Replace the dome assembly. And put everything back. No electricity required. It work automatically when the pump is running. The product appearance and printed words depending on the batch, but this does not affect use Colour:As Shown Material:PVC plastic + steel + brass Package Contents: 1 x Valve top (005-302-4300-03) 1 x Pressure gauge (005-302-3590-00) 1 x Pause assembly (005-302-3502-00) Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.